Efficiency, Differential Temperature and Noise
EfficiencyThe overall efficiency of a power supply is very important, especially when the power supply is designed to deliver over 1,000W DC output. The less waste heat generated the better! Efficiency is defined by the power output divided by the power input and is usually expressed as a percentage. If a PSU were a 100% efficient (which none are) 600 watts of AC power going in would result in 600 watts of DC power coming out (with no waste heat to dissipate). In the real world there are always inefficiencies and power is lost in the form of heat during the conversion process.
The latest revisions to the ATX12V Power Supply Design Guide V 2.2 have continued to increase the efficiency recommendations for PC switching mode power supplies and now lists both required and recommended minimum efficiencies.
I measured the AC power input to the Real Power Pro 1,250W PSU with the Extech power analyzer while the total DC load was found by adding all the individual +3.3V, +5V, +12V, -12V and +5VSB loads together.
(click to enlarge)
The overall efficiency of the CM Real Power Pro 1,250W power supply is excellent and the efficiency appears to peak around 600W. Note that efficiency will almost always be higher at the 240 VAC line voltage versus 115 VAC (as the voltage goes up the current goes down, and since line/component loses are proportional to current, less current means lower loses. And yes, the Real Power Pro 1,250W PSU is 80 PLUS certified.
There is a growing awareness among users, PC manufacturers and electric utilities regarding the money and natural resources that could be saved by adopting higher efficiency power supplies. One group that is spearheading this new movement is Ecos Consulting. You can learn more about their efforts to promote power supplies with better than 80% efficiency by visiting the 80 Plus Program website.
Spending a little more money up front to purchase a high efficiency power supply may very well pay for itself over the lifetime of the PC, especially when you are using this much power… 🙂
Differential Temperature and Noise Levels
To simulate real world operation the Real Power Pro 1,250W power supply was mounted in a modified mid tower case (Lian Li PC60) during testing. Some of the warm exhaust air from the PSU under test is recirculated back into the case, which allows the internal case air temperature to increase with load, just like it would in a real PC. The internal case air temperature is allowed to increase up to 40ºC and then held constant from then on at 40ºC.
The differential temperature across the power supply was calculated by subtracting the internal case air temperature (T in) from the temperature of the warm exhaust air flowing out the back of the power supply (T out).
Thermocouples were placed at the air inlet and exhaust outlet. The ambient room air temperature was 23ºC (74ºF) +/- 0.5ºC during testing.
T out = temperature of air exhausting from power supply
T in = temperature of air entering power supply
Delta T = T out – T in
Sound pressure level readings were taken 3’ away from the rear of the case in an otherwise quiet room. The ambient noise level was ~28 dBA.
Below 600W output and 30°C inlet air temperature, the CM Real Power Pro 1,250W PSU is very quiet to virtually silent. Temperatures gradually build as the load increases and above 600W, the cooling fan starts to speed up to where it becomes noticeable. If you really need a 1,000W+ PSU, you can’t expect it to be quiet at the higher output levels. Even though this power supply is very efficient, it still has to dissipate well over 200 watts of heat at max load and the higher exhaust temperatures reflect that.
Note: I was not able to take SPL readings at the higher loads due to all the programmable DC load cooling fans running.
