A Detailed Look
The Enermax Revolution85+ 1,050W power supply features an industrial-look, textured black matte finish. Both sides are embossed and printed with the Revolution 85+ logo. The steel enclosure measures 190mm (7.5”) long and uses a single, large fan on the bottom for cooling.
The fan speed is automatically controlled by the internal component temperature (speeds up as the combined load and temperature increases) via an onboard controller. The 135mm, 9 blade Globe Fan (RL4Z-B1352512LB-3M) is rated for .28A when operating on 12 VDC. The low speed fan incorporates dual ball bearings and runs between 700 to 1500 rpm depending on load.
The backside panel features an open honey comb grill and includes a power receptacle, master On-Off switch, and the PowerGuard LED status monitor.
(Courtesy Enermax USA)
The Enermax Revolution85+ 1,050W power supply comes with a very good assortment of hard wired and modular cables and connectors for optimum performance and flexibility. All of the cables are covered with Enermax’s classic snakeskin, plastic mesh sleeving and measure approximately 20” to 22” long to the first connectors.
• (1) Main power connector (24-pin/20-pin)
• (1) EPS 12V 8-pin
• (1) EPS 12V 4+4-pin
• (8) PCI Express 8-pin (6+2-pin)
• (6) Peripheral Optical/HDD (4-pin)
• (16) Peripheral Serial ATA (15-pin)
• (1) Peripheral FDD (4-pin)
• (1) PSU Fan speed output cable
There are ten modular cable sockets on the front of the PSU. The six 5-pin black sockets are used for the modular peripheral device cables and the four 12-pin red sockets are used for additional PCI-E cables as well as being available for future expansion if needed. Nine modular cables are included.