UEFI Features continued, Advanced Mode continued
The following screens detail settings on the Monitor, Boot, Tools, and Exit tabs in the Advanced Mode interface.
Monitor tab
Monitor tab, Qfan Tuning popup
Monitor tab, Qfan Tuning report popup
Monitor tab, Voltage Monitor page
Monitor tab, Temperature Monitor page
Monitor tab, Fan Speed Monitor page
Monitor tab, Fan Speed Control page
Monitor tab, Fan Speed Control page continued
Boot tab
Boot tab, Boot Priority and Override settings
Tools tab
Tools tab, ASUS EZ Flash 2 page
Tools tab, ROG Secure Erase page
Tools tab, Graphics Card Information page
Tools tab, ASUS Overclocking Profile page
Tools tab, ASUS Overclocking Profile page continued
Tools tab, ASUS Overclocking Profile page, Load / Save profile page
Tools tab, ASUS SPD Information page
Exit tab
Exit tab, Save Changes & Reset popup
General Help popup
First I heard about the Intel
First I heard about the Intel NiC using up CPU threads for networking… Did you use the driver from the DVD or Intel’s site or the first version of the drivers?
Driver from the DVD was used
Driver from the DVD was used for testing…
The cooler is too big. It’s
The cooler is too big. It’s bigger than the board….
Well, after watching the
Well, after watching the latest podcast#328 mentioning this review, I had too see it for myself. Holy Boulder Dam.. that cooler!!! HAHAHAHA Priceless – Sorry, but I can’t help myself. Good review. Tis a really nice board. And yeah, I really enjoy the podcasts guys!
Hmm, i got this motherboard
Hmm, i got this motherboard in a bundle deal.
One thing they have cheaped out on is the fan control. The z97i plus gets pwm controllers and this is stuck with DC chassis fan controllers, albeit one more, which so far seem to be forcing a case fan to run at 100%…
the ai suite is confusing and has dll exceptions.
I had some issue installing a cooler, if you have an itx case which allows tower coolers it’s ideal but for performance low profile coolers you will struggle. Just about got the silverstone aro06 installed.
So, are you supposed to
So, are you supposed to replace the screws on the CPU Power Daughter card heat sinks with longer screws to mount it to a case? Or do you only need to use the two free mounting holes?