AC Ripple and Noise on the DC Outputs

The amount of AC ripple and noise present on the DC outputs was checked using a digital oscilloscope.  This AC component may be present in the KHz range where most switching power supplies operate or it may be more prevalent at the 60 Hz line frequency.  We adjust the O-scope time base to look for AC ripple at both low and high frequencies.  The ATX12V V2.2 specification for DC output noise/ripple is defined in the ATX12V Power Supply Design Guide.

Ideally we would like to see no AC ripple (repetitive) or noise (random) on the DC outputs – the cleaner the better!  But in reality there will always be some present.  I measured the amplitude of the AC signal (in millivolts, peak-to-peak) to see how well the power supply complied with the ATX standard.  The following table lists the ripple/noise results during all of the load tests for the main output voltages of interest.

SuperNOVA 650 P2:

The 650W P2 power supply exhibited outstanding AC ripple suppression on all of the primary outputs, all the way up to full load.

SuperNOVA 750 P2:

The results for the 750W P2 power supply were also just outstanding!

« PreviousNext »