Testing Configuration and Benchmarks Used
To verify that the motherboard works as advertised, the board was run through our standard benchmark suite. In most cases, the results are presented for the motherboard under review as well as a different similar-class motherboards for performance comparison purposes. The benchmark tests used should give you a good understanding of the board’s capabilities for both office and gaming use so that you, the reader, can make a more informed purchasing decision.
| Test System Setup | |
| Motherboards | Intel Z170-based systems GIGABYTE Z170X-Ultra Gaming ASUS Maximus VIII Extreme Z170A-XPower Gaming Titanium Edition ASUS Z170-A Intel Z97-based system ASUS Z97-Pro Intel X99-based systems ASUS X99-A |
| CPU | Intel Z170-based system Intel Core i7-6700K (4.0GHz CPU and Ring Bus, 40 x 100MHz Base Clock) Intel Z97-based system Intel Core i7-4770K (3.5GHz CPU and Ring Bus, 35 x 100MHz Base Clock) Intel X99-based systems Intel Core i7-5960X (3.0GHz CPU and Ring Bus, 30 x 100MHz Base Clock) |
| Memory | Intel Z170-based system Corsair Vengeance LPX 16GB (2 x 8GB) DDR4-2666 modules (1600MHz, 16-18-18-35-1T, 1.225V) Intel Z97-based system Corsair Vengeance Pro 16GB (2 x 8GB) DDR3-1866 modules (1600MHz, 9-10-9-27-1T, 1.525V) Intel X99-based systems Corsair Vengeance LPX 32GB (4 x 8GB) DDR4-2666 modules (2133MHz, 15-17-17-35-1T, 1.225V) |
| Hard Drive | Intel 730 240GB SSD Western Digital Caviar Black 1TB SATA III HD |
| Sound Card | On-board sound |
| Video Card | NVIDIA GTX 780 3GB |
| CPU Cooling | XSPC Raystorm water block Koolance CPU-360i water block |
| Video Drivers | NVIDIA 353.62 |
| Power Supply | Corsair HX750 |
| Operating System | Windows 10 Pro x64 |
Test Setup Explanation
The 64-bit Windows 10 based test bench used For Intel Z170 LGA1151 board testing includes an Intel Core i7-6700K processor, 16GB of DDR4-2666 memory, an NVIDIA GTX 780 3GB video card, and an Intel 730 240GB SSD drive. For the Z97-based board testing, an Intel Core i7-4770K CPU, 16GB of DDR3-2400 memory, an NVIDIA GTX 780 3GB video card, and an Intel 730 240GB SSD drive were used in the test system. For Intel X99 LGA2011-V3 board testing includes an Intel Core i7-5960X CPU, 32GB of DDR4-2666 memory, an NVIDIA GTX 780 3GB video card, and an Intel 730 240GB SSD drive. Using the selected components gives us the ability to demonstrate the motherboard's capabilities rather than that of the components themselves.
Benchmark Tests used for evaluation:
- SoftPerfect Research NetWorx Speed Test v5.41
- LanBench v1.1.0
- ATTO Disk Benchmark v3.05
- SiSoft Sandra 2015 SP2b (v2015.07.21.42)
- Intel Linpack Benchmark v11.3.0.004
- Maxon Cinebench R15
- PCMark 8 v2.4.304
I wish gigabyte would fix
I wish gigabyte would fix their onboard audio. Their G1 line is overall good with the exception of the audio.
It is not that the audio hardware is bad, but the drivers are really bad.
Currently there is an issue with their realtek drivers where frequencies below 40Hz gets a strange averaging effect which reduces detail in the bass.
This happens on the front outputs, but not on the front outputs if just the realtek drivers are installed. And for the ones that support X-Fi MB3, when the creative software is installed, both the rear and front get the issue regardless of what settings of toggles you mess with.
While the front ports have issues with sub 40Hz sounds, tones within the 41-150Hz range have more detail in the front output.
The real output will do the entire range, but the lower frequencies have less detail,, even though it is the port that is connected to the main audio amp designed to support 600ohm impedance headphones. The other supporting tones for various bass notes have no real presence, and thus you start to get more of the drum sound that you get from midi audio where it sound fake due to it only producing a small set of the frequencies needed to make an instrument sound real., and any attempt to boost those frequencies, results in some slight distortion.
If a generic driver is installed, the issue goes away, but then you lose proper support for 5.1 speaker systems, as well as some of the input functions
I ultimately ended up having to buy a sound blaster Z, because because 3 different boards on their G1 gaming line had the same issue.
I recorded samples of the issue.
Anyway, instead of designing new boards, they need to reallocate some staff to work on the onboard audio.
The funny thing about this is
The funny thing about this is that the Gigabyte boards with audio issues are the higher end ones using the Creative Sound Core chipset as opposed to Realteks.
Maybe a conspiracy theory? After all in your case it net Creative 2 sales!
It might be, considering that
It might be, considering that if the on board drivers worked properly, I would not be able to tell the difference between it and the soundblaster Z.
I was amaze that these board
I was amaze that these board can do a very solid 4.5 (1.32v) and 4.6 (1.35v) Did use the EasyTune for 3 weeks and is easy to use. stable app. The fan app need to be polish and perfected. I box 2 Asus boards since all the issues with there programs and apps. and 1 with VR spikes These board for 160.00 is perfect Imagine other models like Designare or the new Auris.I am happy with these since I get my problems with voltages and app, and I wanted to discard the cpu. And was not. I also recomend these board to everyone. I am still playing with fans on my case since the PWM OP2 beside the case plugs and system 3 fan only reads the PCH Temps. Is a very smart board also. I just change a fan and the bios automatically see that turns off and turn on again and the changes where done. Sound is ok Not the best, miss my Asus on that area, but since that was my last software that works, since just stop working. A nice detail was the app update screen perfect. no more looking for drivers and apps and updates. Gigabyte has to make it better but works perfect. A note. I use my pump from the deep cool captain 360 on the the CPU fan. I also use it on the OPT1 there is NO difference on performance either speeds. on normal. The 3 fans also. I just select PMW the board see that and on these conditions WORKS on both as same.
I will wait of the new Auris bord.
I like how in their promo
I like how in their promo material (3rd picture in the article) coolant tubes pass CPU waterblock without entering it. It’s a nice way to spend crapload of money to quickly fry high-end CPU. EK would be proud of this promotion, i’m sure of it.
😉
Well, it does take extra work
Well, it does take extra work to actually connect the tubes, thus laziness deems it unnecessary.
I saw this and was excited.
I saw this and was excited.
But then they seem to have stripped down the audio compared to other boards in this segment including those from GB.
Realtek 892 instead of 1150. No more Creative X-fi MB3 or equivalent.